 |
|
This Bandit model 95XP arrived, configured with
a whopping 86 HP CAT diesel engine.
This Bandit model 95XP is white and as yet untouched. Will
you be the first to crank its engine? |
 |
 |
A closer look at the awesome CAT 86 HP
diesel engine.
See the control panel with gauges, and
also the clutch and two-position throttle. |
|
This machine is equipped
with an 8 gallon steel fuel tank and a 7 gallon steel hydraulic
tank, as shown here on the right. |
 |
 |
The heart of this unit is a right angle feed system with a single
powerful feed wheel. There is very little distance between the feed
wheel and the chipper knife.
See how the 45" x 30" infeed table just shines.
The opening is 9" high by 16 5/8" wide.
Wouldn't you like to be the first to chip
something in this beauty?
The red and white striped bar above the infeed
allows you to reverse the flow. |
The hydraulic infeed roller brings material
in at an optimal speed to the disk.
Here you can see the hydraulic motor for the
infeed roller.
To the right of the motor is the anvil, where
you make adjustments for optimal chipping. |
 |
|
|
|
 |
 |
Above and left, see the discharge chute.
You can turn
it with the hand crank, and
then lock it in place. |
 |
This wonderful machine comes
with safety chains, electric brakes and lighting.
Left see the hitch and also notice the
break away actuator.
The electrical brakes on this unit are triggered if the wire is
pulled out, bringing it to a halt. |
| Here you see the side view with the infeed tray open. |
 |
 |
Left you can see the cover open to reveal
the 10" knives.
Below is a close up shot of the knives. When they come from the
manufacturer the first knives are painted, showing it has not been
used. |
 |
Four bolts per knife and two knives to change. Knives are double
sided too, so you get more before you have to change in another set. |
| Above, you can see the disc. |
Right, I noticed a first, the handles now
have black plastic coating. |
 |
We
welcome International Sales 